Process instrumentation · selection · supply · technical support | Middle East / Iran / SEA / EU Enquiry: WhatsApp / chat

Flow measurement · conductive liquids

Electromagnetic Flowmeter

Measures the volume flow of conductive liquids with no moving parts — the standard choice for water, wastewater, slurry and chemical dosing. We build the configuration to your line size and process conditions rather than shipping a generic model.

Request a quotation Ask about this model on WhatsApp

Technical summary

Parameters & options

ItemTypical specification*
Nominal diameterDN15 – DN300 (larger on request)
Accuracy±0.5% of reading*
Measured mediumConductive liquids, slurry, water, wastewater
Min. conductivity≥ 5 μS/cm (typical)
Liner optionsPTFE · PFA · rubber · polyurethane*
Electrode material316L · Hastelloy · titanium · tantalum*
Output signal4–20 mA · pulse · Modbus RTU · HART*
Power supply220 VAC · 24 VDC · battery*
ProtectionIP67 / IP68 (submersible version)*
Explosion protectionEx version available for hazardous areas*
ConnectionFlange · wafer · sanitary*

* Typical values for reference. Final range, materials, accuracy and approvals are confirmed per model against your medium, pressure, temperature and site conditions. Datasheet provided on request.

How it works

A magnetic field is applied across the pipe; the conductive liquid moving through it generates a voltage proportional to flow velocity. There are no moving parts in the flow path, so pressure loss is negligible and maintenance is low — which is why it is preferred for dirty water, slurry and chemical service.

Things to confirm before ordering

  • Conductivity of the medium — below the threshold an electromagnetic meter will not measure reliably.
  • Liner and electrode material — must match the chemistry and abrasion of your medium.
  • Full pipe condition — installation should keep the measuring tube full.
  • Grounding and straight-run requirements — we will send the installation note with the datasheet.

Request a quotation — electromagnetic flowmeter

The more you tell us about the medium and line, the more precise our reply.

Chat now

Opens WhatsApp with details prefilled.

FAQ

Electromagnetic flowmeter — common questions

Can it measure oil, gas or steam?

No. Electromagnetic flowmeters require a conductive liquid. For steam, gas or non-conductive liquids, a vortex or other meter is used — see the selection guide.

What minimum conductivity is required?

Typically around 5 μS/cm. Send us the medium and we will confirm suitability before quoting.

Do you offer a submersible or battery-powered version?

Yes, options are available. Tell us the installation and power situation and we will confirm what fits.

What liner and electrode should I choose?

It depends on the medium's chemistry, concentration and abrasiveness. We will recommend the material against your actual service conditions.